Filter
Top Products
v Bits 3 and 8 of n are ignored.
v The Set Print Mode command (see “Set print mode” on page 35) can also
select the character height (double high and double wide). The last
command that is received is the effective command.
v Underline and overline is not supported when the height is scaled 8x.
v The bar for overline and underline is not magnified in thickness
Fix font matrix
Syntax:
ESC : n or X'1B3A;n'
Where:
n The character width to which all proportional characters will be
adjusted. The range of valid values is 8 ≤ n ≤ 32. Use X'00' to
disable this command and print proportional characters normally.
Default:
n=00
Purpose:
To fix the matrix of proportional fonts. This command will be used mostly
to align numbers and decimal points.
Remarks:
v This command is valid only on proportional user-defined fonts.
v If the character is larger than the width defined by this command, then
the right side of the character will be truncated.
v If the character is smaller than the width defined by this command, then
the character will be centered in the space.
Print logo inline
Syntax:
GS J d n1 n2 data or X'1D4A;d;n1;n2;data'
Where:
d Relative height of the character.
0 Single high
1 Double high
n1 MSB of the logo width.
n2 LSB of the logo width.
data The data to form the graphics image.
Purpose:
To print a small logo inline with characters.
Remarks:
v Thermal station only
v Rotate characters must be disabled
v n1 and n2 indicate the number of dots of the bit image in the horizontal
direction. The number of dots is calculated as n1×256+n2 (after first
converting n1 and n2 to decimal).
54 SureMark 4610 Printers : Programming Guide for Models 1xR and 2xR