Filter
Top Products
Purpose:
The printer stops if processing a command and begins its reset routine. The
print buffer is canceled. All commands are erased. All printer settings go
back to default values.
Remarks:
None
Error Conditions:
None
EC/Request/Real-time status request
Syntax:
DLE ENQ 4 or X'100534' Immediate or X'1B008000' Buffered
Purpose:
To send the printer status to the system.
Remarks:
The printer status is returned in status bytes 1–16. Status byte 5 bit is set
after the EC request is executed. When used as a buffered command, this
command can be used to insure that all commands preceding it have been
completed. The application waits for the status to return with Status Bytes
5, bit 1 set. (See Chapter 5, “Status information,” on page 89.)
Error conditions:
None
Retrieve Native Mode Status (when printer is in compatibility
mode)
Syntax:
GS N ENG NULL or X'1D;4E;05;00'
Purpose:
To read the native mode status when in compatibility mode.
Remarks:
16 status bytes of data will be sent over the serial following the status
bytes. Status byte 5 is set, indicating that there is extra data attached.
Note: Supported on 2xR/1NR printers.
Error conditions:
None
Retrieve Native Mode Device ID (when printer is in
compatibility mode)
Syntax:
GS N ENG NULL or X'1D;4E;05;01'
Purpose:
To read out the native mode device ID when in compatibility mode.
Remarks:
Following the 8 compatibility mode status bytes is the native mode device
ID status bytes.
Note: Supported on 2xR/1NR printers.
14 SureMark 4610 Printers : Programming Guide for Models 1xR and 2xR
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|