Filter
Top Products
If the parameter d, w,orh is out of the defined range for this command,
the command is discarded and the remaining data is processed as print
data.
This command will increment status byte 6.
If this message is printed on a regular basis, consider downloading it to
save communication time. (See “Download graphics (logo) commands” on
page 20.)
The data buffer can be used for signature capture.
Print predefined graphics (logo) command
Syntax:
GS / m logo# or X'1D2F;m;logo#'
Where:
m The dot density:
00 Normal Print - 200 dpi in the receipt station, 150 dpi in the
document station.
Note: In the document station, this takes three passes of
the print head for a logo that is 8 dots high.
01 Double wide - 100 dpi in the receipt station, 75 dpi in the
document station.
Note: In the document station, this takes one pass of the
print head for a logo that is 8 dots high.
02 Double wide and high - 100 dpi in the receipt station, 75
dpi in the document station. Every dot row in the vertical
direction will be printed twice.
logo # The number associated with the logo that is stored.
v range=1to40forallmodels
v range=1to255forModels 2CR
Purpose:
To print predefined all-points-addressable print messages.
Remarks:
The margin is ignored if it causes the logo to overrun the line length.
Printing this message in the document station at 150 dpi will take three
passes of the print head.
These messages can be positioned on the page using the commands for
setting positions.
Valid at the beginning of the line only.
This command is not valid in landscape mode.
This command will increment status byte 6.
Retries will not be attempted on print errors.
In the document portrait station, a line-feed command must be sent to
advance the paper past the last line of the logo.
See “Download graphics (logo) commands” on page 20.
Chapter 2. Communication parameters 67