Filter
Top Products
Note: In the document station, this takes three passes of
the print head for a logo that is 8 dots high.
01 Double wide - 100 dpi in the receipt station, 75 dpi in the
document station.
Note: In the document station, this takes one pass of the
print head for a logo that is 8 dots high.
02 Double wide and high - 100 dpi in the receipt station, 75
dpi in the document station. Every dot row in the vertical
direction will be printed twice.
w One-eighth the number of dots in the horizontal direction, (width =
8×w)
range=1to72forathermal logo.
range=1to59foranimpact logo.
In the receipt station,1=8dots = 1 mm.
In the document station,6=48dots = 1 inch.
h One-eighth the number of dots in the vertical direction, (height = 8
× h).
range=1to255forathermal logo.
range=1to5foranimpact logo.
data The data to form the graphics image.
The number of data bytes must be less than 64Kor(hxw)x8<
64K. To print graphics greater than 64K, see “Download graphics
(logo) commands” on page 20 for an example of the data.
Purpose:
To print all-points-addressable print messages.
Remarks:
The margin will be ignored if this causes the logo to overrun the line
length.
These messages can be positioned on the page using the commands for
setting positions.
Not supported in document landscape mode.
To print graphics on the printer when the data is greater:
1. Hold the buffer.
2. Send all the data.
3. Release the buffer.
Note: When the buffer is held, care must be taken to avoid exceeding the
capacity of the printer memory.
The left margin will be rounded down to a factor of 8. For example, if the
margin = 74, the logo starts at 72.
Retries are not attempted on print errors.
Valid at the beginning of the line only.
When printing in the document station, a line feed command must be sent
to advance the paper past the last line of the logo.
66 SureMark 4610 Printers : Programming Guide for Models 1xR and 2xR