Filter
Top Products
Starting DOS
To start up DOS from the additional hard disk attached to the Dock
I, you must change the startup sequence.
To change the startup sequence, do the following.
1.
Install the additional hard disk
to the Dock I.
2.
Check the devices you have
installed or attached.
Then assign serial numbers (1
through 4) only to the hard disk
devices you have checked, from
the top to the bottom of the first
table.
Then assign serial numbers (1
through 2) to the diskette
drives.
The second table shows an
example of a completed table.
ThinkPad Hard Disk in the computer
ThinkPad Hard Disk in the Dock I
Diskette Drive in the computer
Diskette Drive connected to the Dock I
Hard Disk/Diskette Drive
Drive
Number
SCSI Hard Disk (SCSI ID Number 6)
SCSI Hard Disk (SCSI ID Number 5)
SCSI Hard Disk (SCSI ID Number 4)
SCSI Hard Disk (SCSI ID Number 3)
SCSI Hard Disk (SCSI ID Number 2)
SCSI Hard Disk (SCSI ID Number 1)
SCSI Hard Disk (SCSI ID Number 0)
A-4 IBM ThinkPad Dock I User’s Guide
Title: C74AMST CreationDate: 06/23/93 17:09:07