Filter
Top Products
Installing and Removing an Adapter Card
The Dock I can accommodate one full- or half-size, AT-bus 16-bit
adapter card. This section describes the procedures for installing
and removing the adapter card.
Installing an Adapter Card
To install the adapter card in the Dock I, do the following:
1.
Remove the bottom cover.
See “Removing the Bottom Cover” on page 4-3.
Note
Remove the cable guide cover if the cable cannot be routed
through the cable opening.
2.
Remove the screw 2 .
Insert the adapter card into the
expansion slot connector of the
Dock I 1 .
Tighten the screw 2 .
3.
Install the bottom cover.
See “Installing the Bottom Cover” on page 4-5.
You have completed the installation of the adapter card.
4-22 IBM ThinkPad Dock I User’s Guide
Title: C74AMST CreationDate: 06/23/93 17:09:07