Filter
Top Products
5.
Note
If the power connector 2
and the other small
connector (not shown) are
fastened together with a
twist-tie, undo the twist-tie
and separate them.
Insert the SCSI hard disk into
the compartment 4 . Insert the
power connector 2 into the
connector 3 . Insert the
connector 5 into the connector
1 . Push the SCSI hard disk in
until it stops.
Latches
If you need to remove the
SCSI hard disk, you must
release the latches. See
“Releasing the Latches” on
page 4-10.
6.
Install the blank bezel. Perform
the removal procedure in the
reverse order.
See “Removing the Blank Bezel” on page 4-8.
7.
If you have removed an adapter
card, reinstall it.
See “Installing an Adapter Card” on page 4-22.
Chapter 4. Installing and Removing IBM Options 4-15
Title: C74AMST CreationDate: 06/23/93 17:09:07