Filter
Top Products
X'10' Set if the request contains an argument for the EXCLUSIVE
keyword. If set, FCIS_ADDR28 is meaningful.
X'08' Set if the request contains an argument for the BLOCKKEYLEN
keyword. If set, FCIS_ADDR29 is meaningful.
X'04' Set if the request contains an argument for the BLOCKSIZE
keyword. If set, FCIS_ADDR30 is meaningful.
X'02' Not used by file control.
X'01' Not used by file control.
FCIS_BITS5
Existence bits which specify which arguments were specified. The
comments below FCIS_BITS1 also apply to FCIS_BITS5.
X'80' Set if the request contains an argument for the TABLE keyword.
If set, FCIS_ADDR33 is meaningful.
X'40' Set if the request contains an argument for the MAXNUMRECS
keyword. If set, FCIS_ADDR34 is meaningful.
X'20' Set if the request contains an argument for the READINTEG
keyword. If set, FCIS_ADDR35 is meaningful.
X'10' Set if the request contains an argument for the RLSACCESS
keyword. If set, FCIS_ADDR36 is meaningful.
X'08' Not used by file control.
X'04' Not used by file control.
X'02' Not used by file control.
X'01' Not used by file control.
FCIS_BITS6
Specifies whether certain keywords were specified on the File control
SPI command.
X'80' Set if the request contains the START keyword.
X'40' Set if the request contains the NEXT keyword.
X'20' Set if the request contains the END keyword.
X'10' Set if the request contains the WAIT keyword.
X'08' Set if the request contains the NOWAIT keyword.
X'04' Set if the request contains the FORCE keyword.
X'02' Set if the request contains the ENABLED keyword.
X'01' Set if the request contains the DISABLED keyword.
FCIS_BITS7
Specifies whether certain keywords were specified on the File control
SPI command. Also contains the existence bit for JOURNALNUM.
X'80' Set if the request contains the OPEN keyword.
X'40' Set if the request contains the CLOSED keyword.
X'20' Set if the request contains the EMPTY keyword.
X'10' Set if the request contains an argument for the JOURNALNUM
keyword. If set, FCIS_ADDR52 is meaningful.
104 Customization Guide