Filter
Top Products
macros are related and care must be taken to ensure compatibility. The parameters
concerned are identified in the descriptions of the macros later in this chapter.
If you use the sample terminal error program (DFHXTEP), you can generate the
required program and transaction definitions by using the CEDA INSTALL
GROUP(DFHSTAND) command.
Job control for generating the sample terminal error program
The generation of the sample terminal error program consists of two separate
assembly and link-edit steps, one to create the sample TEP module itself, and the
other to create the TEP tables. The names under which the components must be
link-edited are:
DFHTEP
Sample TEP module, assembled from DFHXTEP
DFHTEPT
Sample TEPT table, assembled from DFHXTEPT.
For information about the job control statements necessary to assemble and
link-edit user-replaceable programs, refer to “Assembling and link-editing
user-replaceable programs” on page 436.
DFHTEPM–generating the sample DFHTEP module
The sample DFHTEP module is generated by the following macros:
v DFHTEPM TYPE=USTOR—to indicate the start of user storage definitions.
v DFHTEPM TYPE=USTOREND—to indicate the end of user storage definitions.
v DFHTEPM TYPE=INITIAL—to control the printing of CICS DSECTs, provide
optional routines, and indicate the type of information to be logged when errors
occur.
v DFHTEPM TYPE=ENTRY—to code a user “ENTRY” routine.
v DFHTEPM TYPE=EXIT—to code a user “EXIT” routine.
v DFHTEPM TYPE=ERRPROC—to allow you to replace the error processors
supplied with the sample terminal error program with user-written versions.
v DFHTEPM TYPE=FINAL—to indicate the end of the sample DFHTEP module.
Note: You must code the translator options NOPROLOG and NOEPILOG in your
error processors if you use these macros.
This macro indicates the start of user storage definitions. It must be followed by
your storage definitions, and then by DFHTEPM TYPE=USTOREND. If you use
DFHTEPM TYPE=USTOR to define storage, then both it and DFHTEPM
TYPE=USTOREND must be coded before DFHTEPM TYPE=INITIAL.
This macro indicates the end of user storage definitions. Its use is mandatory if
DFHTEPM TYPE=USTOR has been coded. If you use DFHTEPM TYPE=USTOR to
define storage, then both it and DFHTEPM TYPE=USTOREND must be coded
before DFHTEPM TYPE=INITIAL.
DFHTEPM TYPE=USTOR
DFHTEPM TYPE=USTOREND
Chapter 8. Writing a terminal error program 459