Filter
Top Products
You can examine the EID to determine the type of request and the keywords
specified. You can examine the other parameters in the list to determine the values
of the keywords. You can also modify values of keywords specified on the request.
(For example, you could change the sysid specified in the request.)
End of parameter list indicator
The high-order bit is set on in the last address set in the parameter list to indicate
that it is the last one in the list. On return from your user exit program, CICS scans
the parameter list for the high-order bit to find the last parameter. Therefore, if you
modify the length of the parameter list, you must also reset the high-order bit to
indicate which is the new last address.
For example, if the parameter list specifies only the first two addresses
(TD_ADDR0, the address of the EID, and TD_ADDR1, the address of the name of
the queue named in a DELETEQ request), the high-order bit is set on in
TD_ADDR1. If you extend the parameter list by setting the address of a SYSID in
TD_ADDR7, you must reset the high-order bit in TD_ADDR1 and set it on in
TD_ADDR7 instead.
The maximum size of parameter list is supplied to the exit, thus allowing your exit
program to add any parameters not already specified without needing to first obtain
more storage.
The original parameter list, as it was before XTDEREQ was invoked, is restored
after the completion of XTDEREQC. It follows that the execution diagnostic facility
(EDF) displays the original command before and after execution. EDF does not
display any changes made by the exit.
The UEPCLPS exit-specific parameter:
The UEPCLPS exit-specific parameter is included in both exit XTDEREQ and exit
XTDEREQC. It is the address of the command-level parameter structure. The
command-level parameter structure contains 8 addresses, TD_ADDR0 through
TD_ADDR7. It is defined in the DSECT TD_ADDR_LIST, which you should copy
into your exit program by including the statement COPY DFHTDUED.
The command-level parameter list is made up as follows:
TD_ADDR0
is the address of an 8-byte area called the EID, which is made up as follows:
v TD_GROUP
v TD_FUNCT
v TD_BITS1
v TD_BITS2
v TD_EIDOPT5
v TD_EIDOPT6
v TD_EIDOPT7
TD_GROUP
Always X'08', indicating that this is a transient data request.
TD_FUNCT
One byte that defines the type of request:
X'02' WRITEQ
240 Customization Guide