Intel SDS2 Server User Manual


 
Regulatory and Integration Information Intel® Server Board SDS2
Revision 1.2
Order Number: A85874-002
104
If the host chassis, power supply, and other modules have not passed applicable EMC
certification testing before integration, EMC testing must be conducted on a representative
sample of the newly completed computer.
12.2.2 Ensure Host Computer and Accessory Module Certifications
The host computer and any added subassembly (such as a board or drive assembly, including
internal or external wiring) should be certified for the region(s) where the end product will be
used. Marks on the product are proof of certification. Certification marks are as follows:
12.2.2.1 Europe
The CE marking signifies compliance with all relevant European requirements. If the host
computer does not bear the CE marking, obtain a supplier’s Declaration of Conformity to the
appropriate standards required by the European EMC Directive and Low Voltage Directive. Other
directives, such as the Machinery and Telecommunications Directives, may also apply
depending on the type of product and final configuration.
12.2.2.2 United States
A certification mark by a Nationally Recognized Testing Laboratory (NRTL) such as UL, CSA, or
ETL signifies compliance with safety requirements. Compliance to FCC requirements is also
required. FCC Class A is for commercial or industrial environments; and FCC Class B is for
residential environments.
12.2.2.3 Canada
A nationally recognized certification mark such as CSA or cUL signifies compliance with safety
requirements. EMC compliance to Industry Canada ICE3-003 is required. Class A is for
commercial or industrial environments; and FCC Class B are for residential environments.
12.2.3 Prevent Power Supply Overload
The power supply output must not be overloaded. To avoid overloading the power supply, the
calculated total current load of all the modules within the server should be less than the
maximum output current rating of the power supply. If this is not adhered to, the power supply
may overheat, catch fire, or result in a shock hazard. If the load drawn by a module cannot be
determined by the markings and instructions supplied with the module, contact the module
supplier’s technical support.
12.2.4 Place Battery Marking on Computer
There is insufficient space on this server board to provide instructions for replacing and
disposing of the battery. The following warning must be placed permanently and legibly on the
host server as near as possible to the battery.
WARNING: Danger of explosion if battery is incorrectly replaced.
Replace with only the same or equivalent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer’s instructions.