Filter
Top Products
Intel® Server Board SDS2 BIOS
Revision 1.2
Order Number: A85874-002
51
Code Error Message Failure Description
0614 COM A config. error - device disabled
0615 COM B configuration changed
0616 COM B config. error - device disabled
0617 Floppy configuration changed
0618 Floppy config. error - device disabled
0619 Parallel port configuration changed
061A Parallel port config. error - device disabled
0B00 Rebooted during BIOS boot at Post Code
0B01 Rebooted during OS boot
0B02 Rebooted during OS Runtime
0B1B PCI System Error on Bus/Device/Function PCI system error in Bus/device/Function, PCI
system error in Bus/device/Function
0B1C PCI Parity Error in Bus/Device/Function
0B22 Processors are installed out of order
0B28 Unsupported Processor detected on Processore 1 Unsupported Processor was detected
0B29 Unsupported Processor detect on Processor 2
0B30 Fan 1 Alarm occurred. Fan failed
0B31 Fan 2 Alarm occurred.
0B32 Fan 3 Alarm occurred.
0B33 Fan 4 Alarm occurred.
0B34 Fan 5 Alarm occurred.
0B35 Fan 6 Alarm occurred. Failed Processor#1 because an error was
detected., Failed Processor#2 because an error
was detected.
0B50 Processor #1 with error taken offline
0B51 Processor #2 with error taken offline
0B60 DIMM group #1 has been disabled Memory error, memory group #1 failed
0B61 DIMM group #2 has been disabled Memory error, memory group #2 failed
0B62 DIMM group #3 has been disabled Memory error, memory group #3 failed
0B70 The error occurred during temperature sensor
reading
Error while detecting a temperature failure.
0B71 System temperature out of the range Temperature error detected.
0B74 The error occurred during voltage sensor reading Error while detecting voltage
6.2.5.4 Baseboard Management Controller (BMC) Beep Code Generation
The BMC generates beep codes upon detection of the failure conditions listed in the following
table. Each digit in the code is represented by a sequence of beeps whose count is equal to the
digit.
Table 30. BMC Beep Codes
Code Reason for Beep