Filter
Top Products
Errata Listing Intel® Server Board SDS2
Revision 1.2
Order Number: A85874-002
120
22. Data miscompares when using Seagate* ATA III model
ST310215A hard drives
Problem: Intel has induced data miscompares in SDS2 sytems configured with a
Seagate* ATA III model ST310215A hard drive under extreme workloads during
validation testing. Intel has verfied that other hard drive models are not affected
by this issue.
Implication: The Seagate* ATA III model ST310215A hard drive installed on the Intel® Server
Board SDS2 is currently not a supported configuration and should not be
implemented in a production environment.
Workaround: None.
Status: Fix. Intel has identified a fix for this issue, which will be incorporated in the
SDS2 FAB 5 server board.
23. Boot to service partition via modem fails
Problem: When utilizing the direct platform control (DPC) feature of Intel Server Control
(ISC) v. 3.5.2 software to boot a SDS2 server board to the service partition via
modem, the server board will hang during ROM-DOS load.
Implication: The DPC feature of ISC v. 3.5.2 software cannot be used to remotely boot the
SDS2 server board to the service partion via modem.
Workaround: None.
Status: Fixed. SDS2 BIOS Production Release 2.6, Build 49 and later versions include
a fix for this issue.
24. Secondary IDE References Added To Documentation for FAB
5
Problem: New FAB5 AXXXX-502 has second IDE (ATA 100) connector enabled.
Implication: Users now have second IDE channel for use in system configurations
Workaround: None
Status: Fixed with the release of FAB5 SDS2 severboard in October 2002.
25. Potential Mylex AcceleRAID 352 Adaptor Card Mechanical
Interference at PCI Slot 6.