Filter
Top Products
132 007-4857-002
6: Maintenance and Upgrade Procedures
c. Mount the card in the carrier, (see Figure 6-18) and ensure the following occurs:
– The card connectors protrude through the bulkhead where the metal filler plate was
located.
– The edge connectors fit between the bottom guides of the carrier.
– The top of the card fits under the clips on the guide bar.
d. Tighten the three screws on the guide bar. Skip step 6 and proceed to step 7.
Figure 6-18 Mounting Card in Carrier
Guides
B
ulkhead
Clips