Filter
Top Products
Setting Up Channels for Logical Adapters
90 Interphase Corporation
1. In the Card field, if more than one physical iSPAN-
Serial WAN adapter is installed, select the physical
adapter to be used by the channel.
2. In the Network field, if more than one Frame Relay
network configuration has been created for use by the
NDIS driver, select the network configuration to be
used by this channel.
3. If you need to create, edit, or remove a network
configuration to be used for driver connections, do the
following:
a. Click the Properties button in the Port section of the
Channel properties dialog box.
b. On the Frame Relay protocol properties dialog box,
configure the Frame Relay network properties to use
with this channel. For instructions, see Setting Up
Frame Relay Network Properties on page 155.
All Frame Relay network configurations created in
this dialog box are available for use by all of the
adapter’s NDIS channels and SNA link services.
c. Click OK to save the Frame Relay protocol
properties and return to the Channel properties
dialog box.
NOTE
Because changing the Frame Relay network
configuration changes the adapter firmware, use the WAN
Adapters Setup utility to reload the firmware after making
this change, as described in Saving WAN Adapters Setup
Properties on page 163.