Filter
Top Products
Setting Up Network Protocol Properties
48 Interphase Corporation
To set up IPX/SPX properties for the NDIS logical adapter, do
the following:
1. In the Adapter field, select Interphase 5535 NDIS
Adapter.
2. Select the Manual Frame Type Detection option and
click Add.
3. On the Manual Frame Detection dialog box, select the
Ethernet II frame type (mandatory), and assign a
network number to this adapter interface.
A message informs you that a different number must be
assigned for each adapter installed. Assigning a unique
number for each adapter enables you to access different
networks.
4. Click OK.
After you complete the IPX/SPX configuration, continue as
follows:
• If the TCP/IP protocol is installed, the TCP/IP
Properties dialog box appears. Continue to the next
section, Setting Up TCP/IP Protocols.
• If the TCP/IP protocol is not installed, skip to
Completing the Software Installation on page 51.