Filter
Top Products
Chapter 9: Setting up Firmware and Hardware
iSPAN Serial WAN Adapter Users Guide 163
Saving WAN Adapters Setup Properties
Save any change to WAN adapter firmware, card, and port
properties as follows:
1. Apply the changes by clicking the Apply button.
2. Reload the firmware on the card by clicking the Load
button. Then follow the onscreen instructions.
3. After the properties have been loaded, click OK to save
the reloaded configuration and close the WAN Adapters
Setup dialog box.
The configuration software automatically finds the
relevant firmware for the adapter. It updates the registry
and dynamically updates the drivers.
4. If the Microsoft Windows NT Service Pack is installed,
reinstall the Service Pack. (Service Pack 3 or higher is
recommended.)
5. To activate new settings, restart your computer. (If you
reinstalled the Service Pack, restart the system when
prompted at the end of the Service Pack installation.)
After you have set up firmware and hardware properties, if
have not completed the software installation procedure, return
to the installation steps in the appropriate chapter: