Filter
Top Products
Chapter 8: Setting up SNA Server Link Services
iSPAN Serial WAN Adapter Users Guide 137
Use this dialog box to configure the inserted link service, as
follows:
1. In the Service Title field, change the service title as
needed. This is the title that appears in the title bar of the
dialog box.
2. In the X.25 Local Address field, to configure the
service for back-to-back use, enter the X.25 local
address. The remote computer will use this as the
remote X.25 address to establish the connection.
3. In the Card field, make sure the appropriate adapter is
selected (5535-1P-SR).
4. If you want to change the default firmware or hardware
properties of the adapter, click the WAN Setup button
to start the WAN Adapters Setup utility. Then follow
the instructions in Setting up Firmware and Hardware
on page 145.
5. In the X.25 Network field, select the X.25 network
configuration to be used with the service.
6. If you need to create, edit or remove a network
configuration to be used with the service, do the
following:
a. Click the X.25 Networks button.
b. On the X.25 protocol properties dialog box,
configure the X.25 network to use with this service.
For instructions, see Setting Up X.25 Network
Properties on page 150.
All X.25 network configurations created in this
dialog box are available for use by all of the
adapter’s SNA link services and NDIS channels.