Filter
Top Products
Setting Up Network Protocol Properties
46 Interphase Corporation
Next, set up network protocols for the logical adapter.
Continue to the next section, Setting Up Network Protocol
Properties.
Setting Up Network Protocol Properties
After you add the NDIS logical adapter, one or both of the
following dialog boxes appear:
• Microsoft TCP/IP Properties dialog box
• NWLink IPX/SPX Properties dialog box
This sequence depends on the network protocol(s) installed on
your system.
If your network configuration contains multiple WAN
adapters, you are first prompted to change the default internal
network number to a unique number.
• If the IPX/SPX protocol is installed, click Yes to display
the IPX/SPX Properties dialog box.
• If the IPX/SPX protocol is not installed, click No to
display the TCP/IP Properties dialog box.
Continue as follows:
• To configure IPX/SPX settings, continue to Setting Up
IPX/SPX Protocols on page 47.
• To configure TCP/IP settings, skip to Setting Up
TCP/IP Protocols on page 49.