Filter
Top Products
Chapter 6
Installing and Connecting a Services
Router
Make the appropriate preparations and verify the J-series equipment before installing
a J-series Services Router and connecting it to a power source and the network.
CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the
maximum power and heat capacity of the chassis. If J-series power management is
enabled, PIMs that exceed the maximum power and heat capacity remain offline
when the chassis is powered on.
This chapter contains the following topics:
■ Before You Begin on page 115
■ Unpacking a J-series Services Router on page 116
■ Installing J2320 and J2350 Routers on page 117
■ Installing J4350 and J6350 Routers on page 118
■ Connecting Interface Cables to Services Routers on page 121
■ Chassis Grounding on page 121
■ Connecting Power on page 122
■ Powering a Services Router On and Off on page 127
Before You Begin
Before you begin installation, complete the following tasks:
■ Read the information in “Maintenance and Operational Safety Guidelines and
Warnings” on page 273, with particular attention to “Chassis Lifting
Guidelines” on page 263.
■ Determine where to install the Services Router, and verify that the rack or
installation site meets the requirements described in “Preparing for Router
Installation” on page 101.
■ For installation, gather the following equipment and tools:
Before You Begin ■ 115