Juniper Networks J2320 Network Router User Manual


 
4. Connect the other end of the Ethernet cable to the built-in Ethernet port on the
router.
5. Power on the router by pressing the power button on the front panel.
6.
Wait until the STATUS LED on the front panel turns solid green.
7. Turn on the power to the management device. The router assigns an IP address
to the management device within the 192.168.1.0/24 subnetwork if the device
is configured to use DHCP.
8. From the management device, open a Web browser and enter the IP address
192.168.1.1 in the address field. The Set Up Quick Configuration page appears.
9. Configure basic settings for your router as described in Configuring Basic Settings
with J-Web Quick Configuration on page 141.
NOTE: You must manually configure the IP address for the management port you
are using before you save your initial configuration. When you save the configuration
for the first time, you will lose the connection to the router if you have not manually
configured the IP address. If you lose connection through the management interface,
you must connect through the console port.
Figure 64: Connecting to the Gigabit Ethernet Port on J2320 and J2350 Routers
136 Connecting to a Services Router
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide