Displaying Installed Licenses
Purpose Verify that the expected licenses are installed and active on the Services Router.
Action From the CLI, enter the show system license command.
user@router> show system license
License usage:
Licenses Licenses Licenses
Feature name used installed needed
j-flow 0 1 0
bgp-reflection 0 1 0
dlsw 0 1 0
Licenses installed:
License identifier: G03000002223
State: valid
License version: 2
Valid for device: JN001875AB
Features:
bgp-reflection - Border Gateway Protocol route reflection
License identifier: G03000002224
State: valid
License version: 2
Valid for device: JN001875AB
Features:
dlsw - Data-Link Switching (DLSw) protocol
License identifier: G03000002225
State: valid
License version: 2
Valid for device: JN001875AB
Features:
j-flow - J-FLOW traffic analysis (CFLOW reporting)
What It Means The output shows a list of the license usage and a list of the licenses installed on the
Services Router. Verify the following information:
■ Each license is present. Licenses are listed in ascending alphanumeric order by
license ID.
■ The state of each license is valid.
A state of invalid indicates that the license key is not a valid license key. Either
it was entered incorrectly or it is not valid for the specific device.
■ The feature for each license is the expected feature. The features enabled are
listed by license. An all-inclusive license has All features listed.
■ All configured features have the required licenses installed. The Licenses needed
column must show that no licenses are required.
168 ■ Displaying Installed Licenses
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide