Filter
Top Products
Table 39: TIM514 Possible Port Configurations
Possible Analog Trunk (TRUNK) Port ConfigurationsPossible Analog Telephone (LINE) Port
Configurations
Loop-start or ground-start central office trunk with a loop current of 18
milliamperes (mA) to 120 mA
Wink-start or immediate-start DID trunk
Two-wire analog outgoing centralized automatic message accounting
(CAMA) emergency E911 trunk, for connectivity to the PSTN
Multifrequency (MF) signaling is supported for CAMA ports.
Analog tip/ring devices such as single-line telephones
with or without LED message-waiting indication
The TIM514 also provides the following features:
■ Three ringer loads, the ringer equivalency number for up to 2,000 ft (610 m),
for all eight ports
■ Up to four simultaneously ringing ports
■ Type 1 caller ID and Type 2 caller ID
■ Ring voltage generation for a variety of international frequencies and cadences
For pinouts of cable connectors for the TIM514, see “TIM514 Connector
Pinout” on page 243.
To install or remove an Avaya VoIP module, see “Replacing a PIM” on page 174.
TIM514 LEDs indicate link status and activity. Table 40 on page 75 describes the
meaning of the LEDs.
Table 40: LEDs for TIM514
DescriptionStateColorLabel
Alarm. A TIM514 failure requires
monitoring or maintenance.
On steadilyRed
ALM
Active. A device connected to the
TIM514 is in use. This situation can
include a telephone that is off the
hook.
BlinkingYellow
ACT
For more information about the TIM514, see the Avaya manual Hardware Description
and Reference for Avaya Communication Manager.
TIM521 BRI Telephony Interface Module
The TIM521 BRI Telephony Interface Module (Figure 44 on page 76), also known as
the TIM521 BRI media module, has four ports with RJ-45 jacks that can be
administered as ISDN Basic Rate Interface (BRI) trunk connections. Each ISDN BRI
Avaya VoIP Modules ■ 75
Chapter 3: PIM and VoIP Module Overview