Filter
Top Products
11-7
[2] Copier Initial
Initial settings are the settings that display automatically when the copier is powered
on, when Auto/Reset timer is operated, or when [AUTO RESET] key is pressed.
These settings can be changed by the Key Operator, as shown in this section.
Initially (i.e., at installation), the Basic Screen displays the following conditions to meet
Energy Star requirements:
Initial Setting
Copy Mode : 1-1
Copy Density : AES
Lens Mode : 1:1
Paper Tray : APS
Output Mode : offset sort
When Initial settings are changed by the Key Operator, the new initial settings display
when the copier is powered on, when Auto Reset timer is activated, or when [AUTO
RESET] key is pressed.
The following initial settings can be changed by the Key Operator:
Copy mode : [RADF; 1-1, 1-2, 2-2, 2-1]
Copy density : [AES; manual]
Lens mode : [AMS; ratio 0.25~4.00]
Paper tray : [APS; trays 1, 2, 3, 4, or Multi-sheet bypass tray]
Output mode : [Exit tray 1, 2, 3, 4; Rotation On/Off; Non-sort, Sort,
Group, Staple; Staple location] (machine with Finisher)
[Exit tray 1, 2; Group, Rotation sort, Rotation group;
Rotation On/Off] (machine with Inner tray)
[Group, Rotation sort, Rotation group; Rotation On/Off]
(machine without Finisher)
Non-Image
Area Erase : [Oblique erase, Rectangular erase; Original density]
Setting procedures are described on the following pages.
NOTE:
The most commonly-used settings are established at installation. Before
changing any of the copier settings, be sure that you understand the
overall and long-range effect of the change.
11
Key Operator
Mode
KRDS Host
Density Shift
Application
Customize
List Print
Memory
Switch
Power Save
Touch Panel
Adjustment
Weekly
Timer
Key Operator
Data
Panel Contrast
Paper Type
Lock Job
Memory
E.C.M.
Preset Key
Copier Initial
System Initial
Key Operator
Mode