Filter
Top Products
When “Call for Service” Message Is Displayed (continued)
5-3
3. Unplug the machine.
4. Contact your service representative and report the condition and code
No.
Limited Use of the Copier in Trouble
If the message shown below is displayed on the Call for Service Screen, you may continue
operating the copier on a limited function basis and utilize the trays and ADU that are not
affected by the trouble. To obtain this limited functionality of the copier, consult your
service representative. Be sure to utilize the limited function only temporarily, and arrange
for machine repair immediately.
1. If the limited use of the copier is available, the following message is
displayed in the message area instead of the Report code.
ex.
2. Press [AUTO RESET].
Make note of the Report code No.
3. Turn OFF then ON the power switch.
A copying job can continue without using the troubled portion of the machine (ex. Tray 2).
Even if the copying job can be continued with the above operation, be sure
to contact with your service representative immediately when the Call For
Service Screen is displayed.
Tray 2 failure
Press AUTO to select except this tray
Please switch ON/OFF
E 18-2
5
Trouble-
shooting
Call for
Service
Preventive
Maintenance
Clearing
Mishandled
Paper
JAM Key
ADD PAPER
Key
Memory
Overflow
Power OFF/ON
Screen
Troubleshooting
Tips