Filter
Top Products
Turning On the Power Switch (continued)
2-22
Entering an User ID (User Account)
The User Account (Electronic Copy Monitor) allows the Key Operator to monitor all
copying activities by controlling User ID accounts. Copy quantity limits for specific
accounts can be set.
The User Account (E.C.M.) is not factory-set. An User ID is required only when the User
Account is activated, a User Password is assigned, and “Enter User ID” is displayed on
the touch screen.
Use the following procedures to copy:
For details of the User Account setting, see p. 13-18 to p. 13-26.
1. Enter User ID.
Enter your 8-digit User ID, using the keypad.
For setting a User ID, see p. 13-20 to p. 13-21.
If an invalid User ID is entered, continue by entering the correct ID.
2. Press [START].
Your current copy count and copy limit will be displayed for 3 sec.
3. Start a copying job.
When the message changes to “Ready to copy,” copying job is available on the machine.
When your copy count reaches the copy limit, the message “Copy limit
reached” will be displayed. In that case, contact the Key Operator to reset your
copy limit.
4. Press [#] while pressing [
*
].
The initial state will be restored, with the message “Enter User ID” displayed on the
screen.
Current count / limit
018888/025000