Filter
Top Products
Making Sample Copy (Proof Copy) (continued)
4-3
If the copy result is satisfactory, proceed to step 6.
If any setting changes are required, proceed to the next step.
If the desired selection cannot be changed, press [STOP] to delete all the data
in memory, then press [AUTO RESET] to restart the job setting.
4. Touch EXIT (or press [CHECK]) to return to the Basic Screen.
Change the settings, as required.
5. Repeat steps 3 to 4 until the copy result becomes satisfactory.
6. Change the print quantity, as required.
Proof copy can be performed as needed, until the print quantity amount on the
Basic Screen reaches zero.
If required, change the print quantity on the Basic Screen.
7. Press [START].
If the print quantity is not changed, the copier will output the rest, except the sample sets.
When the finisher / paper exit / inner tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
4
Helpful
Functions
Job Memory
Proof Copy
Check Mode
Help Mode
Interrupt
Mode