Filter
Top Products
Selecting Copy Size (continued)
3-11
To Specify Desired Copy Size (AMS)
When a copy size is specified on the touch screen, an appropriate reduction or
enlargement ratio will be selected automatically according to the original size detected
from the RADF or the platen glass.
• See the table on the following page for the relation of original size, copy
paper size, and magnification ratio.
• Wide paper size can be specified when AMS is in use.
In this case, the same magnification ratio as that of the standard size will be
selected automatically.
• To copy in 1.00 (100%) magnification mode and specifying a copy size, see
p. 3-13.
1. Touch a tray key on the Basic Screen to select the desired paper size.
The selected tray key will be highlighted, and under LENS, -A- will also be highlighted.
2. Select additional copy conditions, as desired.
3. Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
4. Position original(s).
• See p. 10-7 to p. 10-9 for original sizes detectable from the RADF or on the
platen glass.
• See p. 3-2 to p. 3-6 for details on positioning originals.
5. Press [START].
The scanned image will be printed on the specified copy size in the selection
magnification ratio.
Copy result may not be satisfactory due to the Rotation function. In this case,
turn the function OFF manually. See. p. 7-4.
3
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Stop
Scan/Print
Lens Mode
Density
1-1, 2-2
2-1
Staple
Punch
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
Output with
Finisher
Copy Size
Fold/
Fold&Stitch
Output with
Inner Tray