Filter
Top Products
Inserting Images into Printed Sets (Image Insert) (continued)
9-20
6. Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
7. Position originals FACE UP in the document feeder.
If the number of originals exceeds 50, divide them into blocks not exceeding 50 sheets
and load them from the block with the first page.
8. Press [START].
The originals positioned in the document feeder will be scanned into memory.
Repeat steps 7 and 8 for all originals.
9. Scan the platen glass images.
Open the document feeder. Position an original FACE DOWN on the platen glass, then
close the document feeder.
Place and scan the originals according to pagination.
10. Press [START].
Repeat steps 9 and 10 for all originals.
• Memory overflow may occur during scanning. See p. 5-10 to p. 5-11 for
troubleshooting information.
• Should memory overflow occur frequently, it is recommended that you
contact your service representative to expand the memory capacity in your
machine.
11. Touch STORE to exit the Store mode.
12. Press [START].
The copier will start printing when ready for output.
When the finisher / inner / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
For example, if insertion locations are [2/2/6], scanned platen images will be
inserted as follows:
The first scanned platen image will be inserted after page 2.
The second scanned platen image will be inserted directly after the first
scanned image insertion.
The third scanned platen image will be inserted after page 6.
NOTES:
• When a page number is larger than the total original count, a blank sheet is
inserted as the last page.
• Insertions occur in sequence, even if page numbers are entered out of
sequence.
• Entering the same page number twice will insert two sheets at that location.