Filter
Top Products
13: Action Settings
xSenso User Guide 69
Table 13-5 FTP Put Settings
Normal Reminder
Interval
Specify how long to wait in minutes after the alarm stays off before another
normal email is sent. If this is a status report, a normal email is sent periodically
according to the stated reminder interval. Blank the display field to disable
reminders. Email will only be sent once by default.
FTP Put Settings Description
Add an Action
(drop-down menu)
Select FTP Put for the alarm or report. The Host field will appear. You can
create up to 2 connections. Repeat entry for the fields below of each FTP Put
Host.
Host Enter the FTP server IP address or hostname to be connected to. Multiple FTP
Put configuration options will appear.
Reporting Check the types of reporting to include:
Serial Number
System Long Name
Terminal Block
Barrel Connector
Analog Input 1
Analog Input 2
Analog Output 1 (for xSenso 21A2 only)
Analog Output 2 (for xSenso 21A2 only)
Relay Output 1 (for xSenso 21R2 only)
Relay Output 2 (for xSenso 21R2 only)
Note: Your reporting selections made here will apply for all the connections you
make.
Reminder Interval Specify how long to wait in minutes before trying to reconnect to the remote host.
Blank the display field to disable reminders. If more than one Connect host is
specified, connections are attempted without delay; so the single Reminder
Interval applies to the delay between successive attempts to them all. Data will
only be sent once by default.
Port Enter the port number which FTP server is listening to.
Mode Select the mode:
Sequential
Simultaneous
Note: This configuration field appears when more than one connection is
enabled.
Filename Enter the file name to be used to upload to remote FTP server. If file already
exists, new data will be appended to remote file.
Protocol Select the appropriate protocol to connect to the FTP server: FTP or FTPS.
Username Specify the Username for logging on to the FTP server. IF FTP server does not
require authentication, use anonymous.
Password Specify the Password for logging on to the FTP server. IF FTP server does not
require authentication, a common practice is to use user’s email address.
Send Email Settings Description