Lantronix XSENSO 21R2 Switch User Manual


 
xSenso User Guide 77
15: Services Settings
DNS Settings
This section describes the active run-time settings for the domain name system (DNS) protocol.
The primary and secondary DNS addresses come from the active interface. The static addresses
from the Network Interface configuration settings may be overridden by DHCP.
Note: The blue text in the XML command strings of this chapter are to be replaced with
a user-specified name.
Table 15-1 DNS Settings
To View or Configure DNS Settings:
Using Web Manager
To view DNS current status, go to the Admin tab/page and click DNS in the menu.
To lookup DNS name or IP address, go to the Admin tab/page and click DNS in the menu to
access the Lookup field.
Note: To configure DNS for cases where it is not supplied by a protocol, o to the Admin
tab/page, click Network in the menu and select Interface -> Configuration.
Using the CLI
To enter the DNS command level: enable -> dns
Using XML
Include in your file: <configgroup name=”interface” instance=”eth0”>
Setting / Field Description
Lookup Perform one of the following:
Enter an IP address, and perform a reverse Lookup to locate the hostname for
that IP address
Enter a hostname, and perform a forward Lookup to locate the corresponding IP
address