Filter
Top Products
88
Instruction manual V 6.0 - 08/2006
7. Operating the Leica CM3600
To ensure proper operation of the Leica CM3600 as well as use
of the specimen stages and the specimen blocks themselves,
we strongly recommend to attend a Leica application training.
7.1 Check list
The checklist below provides an overview on how to successfully operate
the Leica CM3600.
We recommend that you make a copy of this checklist and
attach it to an instrument surface where it is clearly visible to
ensure that all points of the list are observed.
1. Switch the instrument on.
For further information, refer to chapter 7.2.
2. Start the software.
For further information, refer to chapter 7.3.
3. Select desired chamber temperature for sectioning
For further information, refer to chapter 7.4.
4. Insert the specimen stage.
For further information, refer to chapter 7.5.
5. Insert the knife.
For further information, refer to chapter 7.6.
6. Set the trimming parameters.
For further information, refer to chapter 7.7.
7. Change the knife.
For further information, refer to chapter 7.6.
8. Set the sectioning parameters.
For further information, refer to chapter 7.8.
9. Dehydrate the section.
For further information, refer to chapter 7.9.