Filter
Top Products
94
Instruction manual V 6.0 - 08/2006
7.5.2 Inserting the specimen stage, non-orientable
Tools required:
• Allen key (size 6).
Proceed as follows:
1. Use the knee lever to move the sledge to the right-side reversal point.
For further information, refer to chapters 3.4.2 and 6.4.9.
2. Comply with the safety instructions provided in chapter 7.5.
3. Open the window. For further information, refer to chapter 3.2.3.
4. Remove screw (1).
5 Lift off T-piece (2) and support ring (3).
6. Remove screws (4) and washers (5) located on the right and left side
of the sledge.
7. Insert specimen stage, non-orientable (6) and orient by eye.
8. Put washers (5) in place and tighten screws (4) on the right and left
side of the sledge.
9. Check specimen stage, non-orientable (6) for correct orientation and
proper tightening.
7. Operating the Leica CM3600