Filter
Top Products
121
• Turn the printer off and then on to exit Hex Trace mode and return to Ready status.
• Reset the printer.
Reattach
<device>
What this message means:
The specified device is either not fully connected to the printer or is experiencing a hardware
failure.
What you can do:
•
Reestablish communication by removing the specified device and reattaching it to the printer.
• Press Go to clear the message and continue printing without using the device.
• If a hardware failure occurs, turn the printer off and back on. If the error recurs, turn the printer
off, remove the specified device, and call for service.
Remove Paper
<specified bin>
What this message means:
The specified output bin, or bins, is full.
What you can do:
Remove the stack of paper from the specified bin(s) to clear the message.
Res Reduced
What this message means:
The printer is reducing the resolution of a page in the current job from 600 dots per inch (dpi)
to 300 dpi to prevent a 38 Memory Full error. Res Reduced remains on the display while the
job prints.
What you can do:
Press Menu to open the Job Menu and cancel the current job.