Filter
Top Products
188
Power Saver
Purpose:
To specify the amount of time (in minutes) the printer waits after a job is printed before it goes into a
reduced power state.
Values:
The factory default Power Saver setting depends on your printer model. Print the menu settings page
to determine the current Power Saver setting. When the printer is in Power Saver mode, it is still ready
to receive print jobs.
Select 1 to put the printer in Power Saver mode one minute after it finishes a print job. This uses much
less energy, but requires more warm-up time for the printer. Select 1 if your printer shares an electrical
circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer
ready to print with minimum warm-up time. Select a value between 1 and 240 minutes if you want a
balance between energy consumption and a shorter warm-up period.
If the Disabled value is not available from the Power Saver menu item, see Disabling Power Saver for
more information.
Print Timeout
Purpose:
To specify the amount of time (in seconds) the printer waits before printing the last page of a print job
that does not end with a command to print the page. The print timeout counter does not start until
Waiting is displayed.
Values:
See also:
Print Buffer
Disabled Disables Power Saver; the fuser remains warm and ready to print at all times.
1...240 Specifies the amount of time after a print job before the printer goes into Power Saver
mode. (Your printer may not support the entire range of values.)
Disabled The printer does not print the last page of a print job until one of the following occurs:
• The printer receives enough information to fill the page.
• The printer receives a Form Feed command.
• You select Print Buffer from the Job Menu.
1...225 (90*) The printer prints the last page after the specified time.