Filter
Top Products
55
9.3.4.8. Assembly of the FAN
< Cushion putting position for cooling FAN >
Affixes Fan Cushion X3
It is a thing in the opening
which does not begin to be seen.
Pressurize the frame
within this range or
neither shuttlecock in
the opening nor the
rotation axis.
< Cable fixation seat (FAN/SP) putting position >
FAN externals Flaking off paper ruled line
Affixes Fan/SP Cable Tape
It is a peel putting of
the half of the flaking
off paper.
Safety work
The FAN cable confirms the thing that
beginning to see is not in the concave part.
FAN which has been
prepared is installed.
Pressurize neither rotation
axis nor the shuttlecock.
Do not
transform the frame.
The saliva of FAN is made
to slip into the boss of
a top case under.
Screw(DXHM0057ZA)
Conclusion
Work notes
1. FAN must not be dropped, and do not add the impact.
< SCWER tightening torque >
Conclusion first time power : 0.16-0.18N.m {1.6-1.8kgf.cm}
At the repair : 0.10-0.12N.m {1.0-1.2kgf.cm}
After putting, the backup sheet of
the disk spring is installed.
Disk Cover Arm Spring installation
The point is inserted
in the hole of a top case.
Affixes
Disk Spring Backup Sheet
< putting position of disk spring backup sheet >
Rib
edge side
Do not go out of this
rib heaven side.