Filter
Top Products
72
9.3.6.6. Assembly of the DC Jack Plate
0-0.5
(0-1)
Red lead side
Black lead side
Be careful not to run
aground in this platform
FAN
Sheet
Bottom Case
0-0.5
0-0.5
Pressurize back
side a couple-face
tape part of the
FAN seat
Incert the Connector
Antenna Cable
Be lower to the right
under until hits the
Bottom Case, and
along the Bottom
Case difference side
of the cable
Red lead side
Black lead side
Safety work
Be sure to stick in parallel in
a red line and a black line .
Be careful not to come in
succession.
Peel off the flaking off
paper of a couple-face
tape of the bottom case
preparation, and process
the DC-IN cable
LCD cable/DC-IN cable processing
Tighten DXQT2+E6FNL
Set DC-IN Jack Plate
Set DC MDM Cover
Put the DC-IN Cable
under the substrate
too much.
Do not cross with
the Antenna Cable.
Outside diameter
of boss
FAN sheet pasting position
Fix the DC-IN cable with a
couple-face tape of the botto
case preparation
Put the FAN Sheet
Set Jack.
Put the cylinder part in the
bottom case hole
Prevent metal fittings from
running aground in the
rotation stopper
The LCD cable must pass the
side of the DC MDM cover
9.3.6.7. Putting Main PCB Sheet
Set the cable to the slit part
of the seat, turn the sheet,
and affix
After holding a part of the Main Board
insulation sheet on inside-out and a
tape, stuck the Main Board insulation
sheet on a regular position.
Confirm the thing which
can be operated in the
cable tape maintenance
part
Put Main Board Insulating Sheet
Match the corner hole
to CPU chip and put
CPU externals
CPU
externals
hole
CPU Chip
Maintain the antenna cable
in the part a brim in the Main
Board insulating sheet
Antenna
A
B
Tighten K1YE5000022
A B
K1YE5000022
DFHE5035ZB
Antenna cable processing
After Screw is concluded,
the hole gap prevention tool
is temporarily tightened
Only turn affixation is executed
without the cable when there is
no W-LAN.