Filter
Top Products
2
Installation Tasks
2-25
Installation Tasks
8. At the > prompt, type the user password (default is password)
and press Enter. The password is case sensitive. The New
Connection - HyperTerminal window displays with software and
hardware version information for the product, and a C > prompt
at the bottom of the window.
9. At the C > prompt, type the ipconfig command and press Enter.
The New Connection - HyperTerminal window displays with
configuration information listed:
— MAC Address.
— IP Address (default is 10.1.1.10).
— Subnet Mask (default is 255.0.0.0).
— Gateway Address (default is 0.0.0.0).
— Auto Negotiate.
— Speed.
— Duplex.
Only the IP Address, Subnet Mask, and Gateway Address fields are
configurable.
10. Change the IP address, subnet mask, and gateway address as
directed by the customer. To change the addresses, type the
following at the C > prompt and press Enter.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is xxx.xxx.xxx.xxx, the subnet mask is
yyy.yyy.yyy.yyy, and the gateway address is zzz.zzz.zzz.zzz,
where the octets xxx, yyy, and zzz are decimals from zero through
255. If an address is to remain unchanged, type the current
address in the respective field.
11. Select Exit from the File pull-down menu. A HyperTerminal
message box appears.
12. Click Ye s. A second message box appears. Click No to exit and
close the application.
13. Power off the maintenance terminal and disconnect the RS-232
modem cable. Replace the protective cap over the maintenance
port.
14. At the product front panel, press and hold the IML/RESET
button for ten seconds to perform a POR.