Filter
Top Products
Maintenance Analysis Procedures
3-21
Maintenence Analysis Procedures
6
A loopback (wrap) plug is connected to the port with no diagnostic
running. Remove the plug from the port receptacle. If directed by the
customer, connect a fiber-optic jumper cable attaching a device to the
product.
• If the port is operational with no device attached, both LEDs
adjacent to the port extinguish and the port state is No Light.
• If the port is operational with a device attached, the blue/green
LED illuminates, the amber LED extinguishes, and the port state
is Online.
Was the maintenance action successful?
NO YES
↓ The product port is operational. Exit MAP.
Contact the next level of support. Exit MAP.
7
An ISL connection is not allowed because E_Port capability is
disabled. Install the full-fabric PFE key to enable E_port capability.
Refer to Install PFE Keys (Optional). Exit MAP.
8
The connection timed out because of an unresponsive device or an
ISL security violation (authorization failure reject). Check port status
and clean fiber-optic components.
a. Inform the customer the port will be blocked. Ensure the system
administrator quiesces Fibre Channel frame traffic and sets
attached devices offline.
b. Block the port. Refer to Block or Unblock a Port.
c. Clean fiber-optic connectors. Refer to Clean Fiber-Optic
Components.
d. Unblock the port. Refer to Block or Unblock a Port.
e. Monitor port operation for approximately five minutes.
Was the maintenance action successful?
NO YES
↓ The product port is operational. Exit MAP.