Filter
Top Products
Configuring the System 3-27
3.
Move the appropriate jumpers for your application as shown on the
following figure, “Setting system board jumpers.”
Note
Before setting jumpers, we recommend that you first contact
NECC for assistance (see Chapter 6 for contact information).
The system power must be off before changing
a jumper setting.
4.
Check your settings to be sure that they are correct for your
application.
5.
Replace the system cover (see “Replacing the Cover”). Connect
system power cables and external options.
6.
Power on the system and launch the BIOS Setup Utility before POST
and recustomize your BIOS settings as necessary.