Filter
Top Products
ProSafe VPN Firewall 200 FVX538 Reference Manual
Network Planning for Dual WAN Ports C-17
v1.0, August 2006
VPN Gateway-to-Gateway: Dual Gateway WAN Ports for Load Balancing
In the case of the dual WAN ports on the gateway VPN firewall (Figure C-16), either of the
gateway WAN ports at one end can be programmed in advance to initiate the VPN tunnel with the
appropriate gateway WAN port at the other end as necessary to manage the loads of the gateway
WAN ports because the IP addresses of the WAN ports are known in advance.
The IP addresses of the gateway WAN ports can be either fixed or dynamic. If an IP address is
dynamic, a fully-qualified domain name must be used. If an IP address is fixed, a fully-qualified
domain name is optional.
VPN Telecommuter (Client-to-Gateway Through a NAT Router)
The following situations exemplify the requirements for a remote PC client connected to the
Internet with a dynamic IP address through a NAT router to establish a VPN tunnel with a gateway
VPN firewall at the company office:
• Single gateway WAN port
• Redundant dual gateway WAN ports for increased reliability (before and after rollover)
• Dual gateway WAN ports used for load balancing
Figure C-16
Note: The telecommuter case presumes the home office has a dynamic IP address and
NAT router.
Gateway A
22.23.24.25
netgear1.dyndns.org
10.5.6.0/24
172.23.9.0/24
172.23.9.1
10.5.6.1
WAN_A1 IP
WAN_B1 IP
LAN IP
LAN IP
Gateway B
Gateway-to-Gateway Example
(Dual WAN Ports, Load Balancing)
Fully-QualifiedDomainNames(FQDN)
-optionalforFixedIPaddresses
-requiredforDynamicIPaddresses
VPN Router
(at office A)
VPN Router
(at office B)
WAN_B2 IP
WAN_A2 IP
netgear2.dyndns.org
22.23.24.26