Filter
Top Products
122 | Chapter 7. OSPF
ProSafe M4100 and M7100 Managed Switches
b. Under Interface Configuration, click VLANS to show all the VLAN interfaces.
c. Scroll down and select the interface 0/2/2 check box. Now 0/2/2 appears in the
Interface field at the top.
d. Enter the following information:
• In the OSPF Area
ID field, enter 0.0.0.3.
• In the OSPF Admin
Mode field, select the Enable.
• In the Priority field, enter 255.
• In the Metric Cost field, enter 64.
e. Click Apply to save the settings.
OSPFv3
OSPFv3 is the Open Shortest Path First routing protocol for IPv6. It is similar to OSPFv2 in its
concept of a link state database, intra- and inter-area, and AS external routes and virtual
links. It differs from its IPv4 counterpoint in a number of respects, including the following:
Peering is done through link-local addresses; the protocol is link based rather than network
based; and addressing semantics have been moved to leaf LSAs, which eventually allow its
use for both IPv4 and IPv6. Point-to-point links are also supported in order to enable
operation over tunnels. It is possible to enable OSPF and OSPFv3 at the same time. OSPF
works with IPv4, and OSPFv3 works with IPv6. The following example shows how to
configure OSPFv3 on a IPv6 network.
Area 0
Switch A2Switch A1
Figure 14. OSPFv3 Protocol for IPv6
CLI: Configure OSPFv3
1. On A1, enable IPv6 unitcast routing on the switch.
(Netgear Switch) (Config)#ipv6 unicast-routing