Filter
Top Products
360 | Chapter 19. Switch Stacks
ProSafe M4100 and M7100 Managed Switches
3. Since 2/0/28 is in Ethernet mode, it must be changed to stack mode.
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port 2/0/28 stack
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)
4. Reboot Switch B.
(Netgear Switch) #reload
Management switch has unsaved changes.
Would you like to save them now? (y/n) n
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n) y
Reloading all switches.
On Switch A, you see the following:
(Netgear Switch) #show switch
Management Standby Preconfig Plugged-in Switch Code
SW Switch Status Model ID Model ID Status Version
--- ---------- -------- ----------- ----------- --------- -----------
1 Mgmt Sw GSM7352Sv2 GSM7352Sv2 OK 8.0.1.2
2 Stack Mbr Oper Stby GSM7328Sv2 GSM7328Sv2 OK 8.0.1.2
Web Interface: Stack Switches Using 10G Fiber
1. On Switch A, show the Port Information.
a. Select System > Stacking >
Advanced > Stack Port Configuration.
A screen similar to the following displays.
b. Since the port 1/0/52 is stack mode already, nothing needs to be done.
2. On Switch B, configure port 2/0/28 as stacking port.
a. Select System > Stacking >
Advanced > Stack Port Configuration.