Filter
Top Products
248 | Chapter 13. IGMP Snooping and Querier
ProSafe M4100 and M7100 Managed Switches
CLI: Show mac-address-table igmpsnooping
(Netgear Switch) #show mac-address-table igmpsnooping ?
<cr> Press Enter to execute the command.
(Netgear Switch) #show mac-address-table igmpsnooping
Type Description Interfaces
----------------------- ------- -------------- -----------
00:01:01:00:5E:00:01:16 Dynamic Network Assist Fwd: 1/0/47
00:01:01:00:5E:00:01:18 Dynamic Network Assist Fwd: 1/0/47
00:01:01:00:5E:37:96:D0 Dynamic Network Assist Fwd: 1/0/47
00:01:01:00:5E:7F:FF:FA Dynamic Network Assist Fwd: 1/0/47
00:01:01:00:5E:7F:FF:FE Dynamic Network Assist Fwd: 1/0/47
Web Interface: Show mac-address-table igmpsnooping
Select Switching > Multicast > IGMP Snooping Table. A screen similar to the following
displays.
External Multicast Router
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure the Switch with an External Multicast Router
This example configures the interface as the one the multicast router is attached to. All IGMP
packets snooped by the switch is forwarded to the multicast router reachable from this
interface.
(Netgear Switch)(Interface 1/0/3)# set igmp mrouter interface