Filter
Top Products
356 | Chapter 19. Switch Stacks
ProSafe M4100 and M7100 Managed Switches
CLI: Configure a Stacking Port as an Ethernet Port
1. On Switch A, Configure the Stack Port and Reboot
(Netgear Switch) #show stack-port
Configured Running Link
Stack Stack Link Speed
Unit Intf SlotId Type XFP Adapter Mode Mode Status (Gb/s)
---- ----- ------ ------ ----------- ------- ------ ----- -----
2 0/27 None Stack Stack Link Down 0
2 0/28 AX742 (stack) Stack Stack Link Down 12
(Netgear Switch) #config
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port 2/0/28 ethernet
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #reload
Are you sure you want to reload the stack? (y/n) y
(Netgear Switch) #show port 2/0/28
Admin Physical Physical Link Link LACP Actor
Intf Type Mode Mode Status Status Trap Mode Timeout
------ ----- ------- -------- --------- ------ ------- ------- ------
2/0/28 Enable 10G Full 10G Full Up Enable Enable long
After Switch A reboots: