Filter
Top Products
Reference Guide for the Model RP114 Web Safe Router
Using the Manager Interface to Configure the Router for Internet Access 8-9
After defining filters in Menu 21, apply the filters to the Remote Node by entering the filter
number in Menu 11.5 - Remote Node Filters. You can cascade up to four filter sets by entering the
numbers of the desired filter sets, separated by commas and with no spaces between them.
Menu 11.5 - Remote Node Filters is shown in Figure 8-5.
Figure 8-5. Menu 11.5 - Remote Node Filters
Table 8-3 describes the fields of the Remote Node Filters display.
For more information on using filters, refer to Chapter 10, “Configuring Filters.”
Table 8-3. Remote Node Filters Fields
Field Description
Input, Output, and
Call Filters
Protocol Filters
Device Filters
These categories allow the application of filters to incoming data or outgoing data,
and they cause or prevent the placement of outgoing calls.
Enter the filter numbers of IP packet format filters defined in Menu 21.
Enter the filter numbers of generic packet format filters defined in Menu 21.
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 3
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters= 1
device filters=
Press ENTER to Confirm or ESC to Cancel: