NETGEAR RP114 Network Router User Manual


 
Reference Guide for the Model RP114 Web Safe Router
Using the Manager Interface to Configure the Router for Internet Access 8-15
4.
Press [Enter] at the Press ENTER to Confirm... prompt to save your selections, or press [Esc]
at any time to cancel your selections.
Static Route Example
As an example of when a static route is needed, consider the following case:
Your primary Internet access is through a cable modem to an ISP.
You have an ISDN router on your home network for connecting to the company where
you are employed. This router’s address on your LAN is 192.168.0.10.
Your company’s network is 134.177.0.0.
When you first configured your Model RP114 router, two implicit static routes were created. A
default route was created with your ISP as the gateway, and a second static route was created to
your local network for all 192.168.x.x addresses. With this configuration, if you attempt to access
a device on the 134.177.0.0 network, your router will forward your request to the ISP. The ISP
forwards your request to the company where you are employed, and the request will likely be
denied by the company’s firewall.
In this case you must define a static route, telling your router that 134.177.0.0 should be
accessed through the ISDN router at 192.168.0.10. The static route would look like Figure 8-9.
Metric Enter the cost of transmission for routing purposes. IP routing uses hop
counts as the measurement of cost, with a minimum of 1 for directly
connected networks. Enter a number that approximates the cost for this link.
The number does not have to be precise, but it must be between 1 and 16. In
practice, 2 or 3 is usually a good number.
Private Use this field to determine whether the router includes the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept private and
not included in any RIP broadcast. If set to No, the route to this remote node
is propagated to other hosts through RIP broadcasts.
Table 8-5. Edit IP Static Route Fields (continued)
Field Description