Setting Up Windows Components
RFM-4002-5015 Rev 3
39
Installing the Dial-Up Adapter
The following table describes the steps for installing the Dial-Up Adapter.
Windows 95/98/ME
1 From the Select Network Adapter window, highlight
Dial-Up Adapter in the Network Adapters list.
2 Under Manufacturers, highlight Microsoft. Click OK.
3 The Select Network Component Type window opens.
Highlight Adapter. Click Add.
4 The Select Network Adapters window opens.
5 To verify that the adapter was added, from Start, select
Settings.
• Select Control Panel.
• Click Network.
• Look for Dial-Up Adapter on the Network
Configuration screen.
Windows NT/2000
The Dial-Up Adapter may not have been included in the standard installation.
The following steps describe how to check that TCP/IP is in fact installed, and
if necessary add the TCP/IP protocol.
NOTE: This may require that you contact your IT Representative or
System Administrator.
1 Select Start Settings
Control Panel. The Control
Panel window opens. Double click on Network and Dial
Up Connections.
The
Network and Dial Up Connections
window opens.
Double click on Make New Connection which brings up
