Filter
Top Products
iR1200 Modem
58 nextel.com
Configuration
Command Syntax AT&F
Expected Return Code(s) OK
Activate DTR Monitoring
The DCE does not monitor the DTR line of the DTE/DCE physical connection.
This is the default factory setting. To activate DTR monitoring in the DCE, you
must apply the following command.
AT Command DTR Behavior
Command Syntax AT&D2
Expected Return Code(s) OK
Activate DCD Management
The factory default for the modem keeps the Data Carrier Detect (DCD) line of
the computer-to-modem physical connection active at all times. Some
communication programs monitor this line to determine the status of the
connection. To promote compatibility with these programs, enable DCD
management in the modem.
AT Command DCD Behavior
Command Syntax AT&C1
Expected Return Code(s) OK
Set Computer’s IP Address
Inform the modem of the computer’s IP address to establish SLIP or PPP
connection between the modem and the computer.
AT Command Computer IP Address
Command Syntax AT+WPNEI=XXX.XXX.XX,