Filter
Top Products
186 Configuring authentication
Table 35
RADIUS authenticaion servers (cont’d.)
/cfg/doamin #/aaa/auth #/radius/servers
followed by:
insert <index number>
<IPaddr>
Inserts a server at a particular position in the
list of RADIUS authentication servers in the
configuration.
•
index number—the index number you
want the server to have
• IPaddr—the IP address of the
authentication server you are adding
The index number you specify must be in use.
The index numbers of existing servers with this
index number and higher are incremented by
1.
move <index number> <new
index number>
Moves a server up or down the list of RADIUS
authentication servers in the configuration.
•
index number—the original index number
of the server you want to move
• new index number—the index number
representing the new position of the server
in the list
The index numbers of the remaining entries
adjust accordingly.
Configuring session timeout
You can configure the Nortel SNAS to enable session timeout and to
retrieve a session timeout value from the RADIUS server. With session
timeout enabled, the session timeout value controls the length of the
client’s Nortel SNAS network session. When the time is up, the client is
automatically logged out. Idle time has no effect on the session timeout.
To configure the Nortel SNAS for session timeout, use the following
command:
/cfg/doamin #/aaa/auth #/radius/sessiontim
The Session Timeout menu appears.
The Session Timeout menu includes the following options:
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.